ctrl_iface not configured

Nithin Chakravarthi nithin at embdestech.co.in
Fri Aug 8 06:08:41 EDT 2014


Hii all,

 I have hostapd 2.2 running on Ubuntu 12.04
when i run hostapd  this is the log
log:
WPA: Start group state machine to set initial keys
WPA: group state machine entering state GTK_INIT (VLAN-ID 0)
GTK - hexdump(len=16): [REMOVED]
WPA: group state machine entering state SETKEYSDONE (VLAN-ID 0)
wpa_driver_nl80211_set_key: ifindex=5 (wlan1) alg=3 addr=0x4a4f8 key_idx=1
set_tx=1 seq_len=0 key_len=16
nl80211: KEY_DATA - hexdump(len=16): [REMOVED]
   broadcast key
nl80211: Set wlan1 operstate 0->1 (UP)
netlink: Operstate: ifindex=5 linkmode=-1 (no change), operstate=6
(IF_OPER_UP)
Failed to set TX queue parameters for queue 0.
Failed to set TX queue parameters for queue 1.
Failed to set TX queue parameters for queue 2.
Failed to set TX queue parameters for queue 3.
wlan1: interface state UNINITIALIZED->ENABLED
wlan1: AP-ENABLED
wlan1: Setup of interface done.
ctrl_iface not configured!

It says AP enabled. But it is not detected by any other device
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.shmoo.com/pipermail/hostap/attachments/20140808/18a251d8/attachment.htm>


More information about the HostAP mailing list