<div dir="ltr">Hii all,<div><br></div><div> I have hostapd 2.2 running on Ubuntu 12.04</div><div>when i run hostapd this is the log</div><div>log:</div><div><div>WPA: Start group state machine to set initial keys</div><div>
WPA: group state machine entering state GTK_INIT (VLAN-ID 0)</div><div>GTK - hexdump(len=16): [REMOVED]</div><div>WPA: group state machine entering state SETKEYSDONE (VLAN-ID 0)</div><div>wpa_driver_nl80211_set_key: ifindex=5 (wlan1) alg=3 addr=0x4a4f8 key_idx=1 set_tx=1 seq_len=0 key_len=16</div>
<div>nl80211: KEY_DATA - hexdump(len=16): [REMOVED]</div><div> broadcast key</div><div>nl80211: Set wlan1 operstate 0->1 (UP)</div><div>netlink: Operstate: ifindex=5 linkmode=-1 (no change), operstate=6 (IF_OPER_UP)</div>
<div>Failed to set TX queue parameters for queue 0.</div><div>Failed to set TX queue parameters for queue 1.</div><div>Failed to set TX queue parameters for queue 2.</div><div>Failed to set TX queue parameters for queue 3.</div>
<div>wlan1: interface state UNINITIALIZED->ENABLED</div><div>wlan1: AP-ENABLED </div><div>wlan1: Setup of interface done.</div><div>ctrl_iface not configured!</div></div><div><br></div><div>It says AP enabled. But it is not detected by any other device</div>
</div>