Harshil Anil Kumar Shah
Harshil_Shah at infosys.com
Mon Feb 14 00:28:03 EST 2011
I want to perform EAP-TLS pre-authentication. I have setup following testbed.
(Mobile)--------- wireless------- (Current AP) --------------- wired ----------------- (Next AP) -------------------- wired ----------------- (AAA server)
192.168.1.203 192.168.1.1 192.168.1.4 192.168.1.10
I have configured the radius IP on Next AP. But what configuration I have to do on Current AP so that It can recognize that request coming from mobile as an EAP request and forwards it to next AP.
Current AP : Dlink DIR 600 wireless router
Next AP: Cisco catalyst 2960 G switch.
Thanks in advance.
Thanks and Regards,
Harshil A. Shah,
Convergence Labs, SETLabs
Infosys Technologies Limited | Bangalore
Mob # : +91 97428 87966.
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are not
to copy, disclose, or distribute this e-mail or its contents to any other person and
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken
every reasonable precaution to minimize this risk, but is not liable for any damage
you may sustain as a result of any virus in this e-mail. You should carry out your
own virus checks before opening the e-mail or attachment. Infosys reserves the
right to monitor and review the content of all messages sent to or from this e-mail
address. Messages sent to or from this e-mail address may be stored on the
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the HostAP