Prism wireless lan card is causing time-travel
anthony at magix.com.sg
Thu Jan 16 10:10:48 EST 2003
I have a wireless lan card based on the Prism 2 chipset, branded by Corega,
who are quite a big brand here in Japan. (details below)
Whenever I install the hostap driver (http://hostap.epitest.fi/),
using "modprobe hostap_plx", the module loads fine, but the whole
machine's sense of time gets very confused.
The problem continues even when I remove the module.
Asking on the hostap list a month or two ago brought no joy,
and I can't find anyone else reporting a similar problem, so
I'm wondering if it's just broken hardware.
The effect can be seen with a shell loop to call /bin/date.
For a few milliseconds around each second, the time jumps
forward more than an hour, and then resets itself.
Updating the firmware on the card doesn't improve things,
nor does installing the card in a different PC.
Can anyone suggest what the problem might be, or how I
could debug it further?
Linux begemot.ajrh.net 2.4.20 #20 SMP Thu Jan 16 23:04:42 JST 2003 i686 Intel(R) Xeon(TM) CPU 2.66GHz GenuineIntel GNU/Linux
05:0d.0 Network controller: National Datacomm Corp Wireless PCI Card (rev 02)
Subsystem: Allied Telesyn International: Unknown device a113
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 21
Region 0: Memory at ff2ff400 (32-bit, non-prefetchable) [size=128]
Region 2: Memory at ff2ff000 (32-bit, non-prefetchable) [size=1K]
Region 3: I/O ports at ccc0 [size=64]
More information about the HostAP