[vpn] newbie setting up vpn
Ryan Malayter
rmalayter at bai.org
Mon Jun 17 12:50:50 EDT 2002
Well, considering that you have two networks with the exact same
addressing scheme, you're in a lot of trouble. You'll have to re-address
one of the networks (192.168.1.x) to ever have any hope of connectivity
between the two.
-----Original Message-----
From: Nate Harel [mailto:nharel at nettech-services.net]
Sent: Sunday, June 16, 2002 6:46 PM
To: vpn at securityfocus.com
Subject: [vpn] newbie setting up vpn
Hi all,
Forgive my ignorance here but I am trying to set up a small vpn
connection
between two offices.
Office A:
win2k machine on a small network behind a Netgear router. I set up the
router to forward vpn traffic on port 1723 to the Win2K machine. That
machine has been setup to accept incoming calls. I set up the local
network
using 192.168.0.x addresses. I configured the incoming connection to
accept
calls from networks with that address range. I also made the Office A
local
disk shared.
Office B:
WinXP machine on a small network behind a Netgear router. Again, I setup
the router to forward vpn traffic on port 1723. That machine was setup
with
an outgoing vpn connection to Office A with an IP address of
192.168.0.100.
This local network is also 192.168.0.x.
From Office B, I dial out to Office A and get a connection. I can see
the
connection being made at A. So far all is well. HOWEVER, from B, I
cannot
see any of Office A's network, files, computers, etc. It is almost like
there is no connection at all.
HELP!! I am stumped.
Nate
----------------------------------
Nate Harel
NetTech Services
56 Pickering Street
Needham, MA 02492
Tel: 1-781-559-8176
Toll Free: 1-877-567-8936
FAX: 1-877-567-8936
Email: nharel at nettech-services.com
www.nettech-services.net
www.nettech-backup.com
www.nettech-hosting.com
----------------------------------
VPN is sponsored by SecurityFocus.com
VPN is sponsored by SecurityFocus.com
More information about the VPN
mailing list