<div dir="ltr">Hi all,<div>I have been making some tests with 11r and also with HS 2.0. I have two APs properly configured to both, operate with 802.11r ando to poperate with HS 2.0 capabilities. The issue comes when I try to perform a handover with 11r using at the same time HS 2.0, I mean:</div><div><br></div><div>- I connect the terminal (Samsung S4) to one AP without using HS 2.0 (adding manually the EAP profile) and it roams perfectly to second AP using 11r.</div><div><br></div><div>- But, when I connect the terminal using HS 2.0 (profile autogeneration) it is not able to roam from one Ap to another using 11r.</div><div><br></div><div>Anyone else has the same issue?</div><div><br></div><div>My AP configuration is:</div><div><br></div><div>*************************************************************<br><div>interface=wpriv</div><div>ctrl_interface=/var/run/hostapd-phy0</div><div>ap_isolate=1</div><div>disassoc_low_ack=1</div><div>preamble=1</div><div>auth_server_addr=OMITTED</div><div>auth_server_port=OMITTED</div><div>auth_server_shared_secret=OMITTED</div><div>disable_pmksa_caching=1</div><div>okc=0</div><div>acct_server_addr=OMITTED</div><div>acct_server_port=OMITTED</div><div>acct_server_shared_secret=OMITTED</div><div>nas_identifier=<a href="http://ap1.test.com">ap1.test.com</a></div><div>eapol_key_index_workaround=1</div><div>ieee8021x=1</div><div>wpa_key_mgmt=FT-EAP WPA-EAP</div><div>interworking=1                                                           </div><div>internet=1                                                               </div><div>asra=0                                                                   </div><div>esr=0                                                                    </div><div>uesa=0                                                                   </div><div>ipaddr_type_availability=1C                                              </div><div>access_network_type=3                                                    </div><div>venue_group=7                                                            </div><div>venue_type=1                                                             </div><div>venue_name=eng:Test                                    </div><div>domain_name=<a href="http://test.com">test.com</a>                                                      </div><div>nai_realm=0,<a href="http://test.com">test.com</a>,21[2:4]                                              </div><div>hs20=1                                                                   </div><div>disable_dgaf=0                                                           </div><div>osen=0                                                                   </div><div>hs20_deauth_req_timeout=0                                                </div><div>hs20_oper_friendly_name=eng:Test                          </div><div>auth_algs=1</div><div>wpa=2</div><div>wpa_pairwise=CCMP</div><div>ssid=HS20_Test</div><div>bridge=br-lan</div><div>wmm_enabled=1</div><div>bssid=OMITTED</div><div>ignore_broadcast_ssid=0</div><div>mobility_domain=a1b2</div><div>r0_key_lifetime=10000</div><div>r1_key_holder=000102030405</div><div>reassociation_deadline=1000</div><div>r0kh=MAC_AP_1 <a href="http://ap1.test.com">ap1.test.com</a> 010102030405060708090a0b0c0d0e0f</div><div>r0kh=MAC_AP_2 <a href="http://ap2.test.com">ap2.test.com</a> 030102030405060708090a0b0c0d0e0f</div><div>r1kh=MAC_AP_2 00:01:02:03:04:06 020102030405060708090a0b0c0d0e0f</div><div>ft_over_ds=0</div><div>pmk_r1_push=1</div></div><div><div>*************************************************************<br></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div><div>I think the problem lies on the config line below:</div><div><br></div><div>wpa_key_mgmt=FT-EAP WPA-EAP<br></div><div><br></div><div>Probably, the HS 2.0 profile generation selects WPA-EAP instead of FT-EAP, but I am not sure of this.</div><div><br></div><div><br></div><div>On the other hand, Jouni points me some time ago to the 802.11ai amendment as a mean to enhance handover experience. Is there any plan to include support of it in hostapd in the near future?</div><div><br></div><div>Thanks a lot,</div><div>Adrián</div>
</div></div>