<div dir="ltr"><div><div><div><div><div>Hi,<br><br></div>I can set up my wireless card as an AP, as a STA, or as both AP and STA. What I want to do next is set it up as an AP with two SSIDs (one will be WPA2, and one will be open). I have groped around through various postings, and I *think* iw is telling me I can&#39;t do it, but wanted to make sure.<br><br>The card is as follows (from dmesg):<br><br>        ieee80211 phy0: Atheros AR9300 Rev:3 mem=0xa0c80000, irq=155<br><br></div>Amidst all the &quot;iw list&quot; output, I have:<br><br>        valid interface combinations:<br>                 * #{ managed, WDS, P2P-client } &lt;= 2048, #{ AP, P2P-GO } &lt;= 8,<br>                   total &lt;= 2048, #channels &lt;= 1, STA/AP BI must match<br>                 * #{ AP } &lt;= 1,<br>                   total &lt;= 1, #channels &lt;= 1, STA/AP BI must match, radar detect widths: { 20 MHz (no HT), 20 MHz }<br><br></div>I have only seen the information in the first bullet in other postings, and if I had only that, I&#39;d assume dual SSIDs was possible. However, I think the second bullet is telling me I can only have one AP. Is that right? If so, then is the correct interpretation of this output that the maximum number of APs I can run is one (second bullet), and the maximum of the sum of the number of APs and P2P-GOs I can have is eight, e.g. one AP + seven P2P-GO, or zero AP + eight P2P-GO.<br><br></div>I do not mind searching around to figure out how to make it work, but I think it is already telling me no-go, and just wanted to confirm.<br><br></div><div>While we&#39;re here :), I have interpreted &quot;#channels &lt;= 1&quot; to mean that when I&#39;m running AP and STA at the same time, they must be on the same channel. That is working fine, but I&#39;d also like to confirm that I&#39;m interpreting it correctly and am not being overly restrictive.<br></div><div><br>Thanks!<br></div>John<br></div>