<div>On Mon, Mar 19, 2007 at 08:45:55PM -0700, hong zhang wrote:<BR><BR>&gt;&gt;&nbsp;&nbsp; Version 4.9 hostapd will cause segmentation fault sometimes on <BR>IXP425--Gatework 2348 board. The chance is 50%. When I run "hoastapd <BR>ap_conf", it returns following even after I do "echo 2 &gt; <BR>/proc/cpu/alignment". See following errors message,<BR>&gt;&nbsp;&gt;&nbsp;&nbsp; <BR>&gt;&nbsp;&gt;&nbsp; Bad mode in data abort handler detected: mode IRQ_32<BR>&gt;&nbsp;&gt;&nbsp; Internal error: Oops - bad mode: 0 [#1]<BR>&gt;&nbsp;&gt;&nbsp; Modules linked in: wlan_ccmp wlan_acl wlan_tkip wlan_xauth wlan_wep <BR>ath_pci ath_hal ath_rate_onoeCPU: 0<BR>&gt;&gt;&nbsp;&nbsp; PC is at 0xffff0204<BR>&gt;&gt;&nbsp;&nbsp; LR is at zz002db51c+0x44/0x3b4 [ath_hal]<BR><BR>&gt;I've tested hostapd on ixp425, but have not seen something like this<BR>&gt;show up. Then again, I haven't tested it with madwifi driver on ixp425.<BR>&gt;This kernel oops looks more like an indication of a bug in
 the kernel<BR>&gt;driver (maybe in ath_hal module) than an issue in hostapd.. Have you<BR>&gt;tried using this device as an AP without hostapd (e.g., in plaintext<BR>&gt;mode and configure the interface with iwconfig and ifconfig)?<BR>&gt;Jouni Malinen&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; PGP id <BR>&gt;EFC895FA</div>  <div>&nbsp;</div>  <div>Yes, I set this device as AP without hostapd and never has this problem.</div>  <div>I can ifconfig ath0 up, iwconfig ath0 and iwconfig ath0 channel 1, etc.. I am going to run hostapd with plain mode tomorrow.<BR><BR></div>