Hello,<br><br>Using Wpa_sup and cli 5.4 for Windows, I haven't (don't know the procedure?) to connect to a network then disconnect and connect to another:<br><br>I have a config file with 3 or 4 network &quot;profiles&quot; all disabled=1.
<br><br><ol><li>I start wpa_sup.&nbsp; And it initializes properly (I think). <br><br>
</li><li>I start wpa_cli (no parms).&nbsp; I indeed have a connection between the 2; I sucessful send commands to the sup via the cli app.<br><br>
</li><li>I can successfully enable on of the networks and get it to connect.&nbsp; I believe I do the following:</li><ol><li>list the networks</li><li>enable the one I want</li><li>select the one I want (not sure the difference between enable and select)
</li><li>reassociate. <br>
  <br>


</li></ol><li>Then I disconnect.<br>

  <br>



  </li><li value="5">Trying to repeat the substeps of Step 3. to connect to a different network (or the same again) doesn't establish the connection.<br>

  <br></li></ol>I must be leaving out a step or the procedure is incorrect from the start.<br><br><br>any idea?<br><br>george<br>
<br>
<br>