Regarding the suggestion that I try the hostap driver, here is what I did:<br>
<br>
At boot, no drivers are loaded.&nbsp; <br>
<br>
# modprobe hostap<br>
# ifconfig <br>
<br>
Only the loopback device is listed.&nbsp; Apparently the hostap driver didn't find anything.<br>
<br>
# hostap_diag -a eth0<br>
ioctl[PRISM2_IOCTL_HOSTAPD]:&nbsp; No such device<br>
Could not communicate with the kernel driver.<br>
<br>
(OK, so let's try adding orinoco_pci)<br>
<br>
# modprobe orinoco_pci<br>
# ifconfig<br>
<br>
Now eth0 is listed, I'm able to bring up the card and get an IP address, but the hostap_diag command<br>
still gives the same error.&nbsp; Any guidance?&nbsp; There doesn't appear to be too much documentation out there on<br>
hostap_diag.<br>
<br>
Harold Naparst<br><br>---------- Forwarded message ----------<br><span class="gmail_quote">From: <b class="gmail_sendername">Harold Naparst</b> &lt;<a href="mailto:hnaparst@gmail.com">hnaparst@gmail.com</a>&gt;<br>Date: Jul 25, 2005 10:48 AM
<br>Subject: Flashing a Prism 2.5 card<br>To: <a href="mailto:hostap@shmoo.com">hostap@shmoo.com</a><br><br></span>I'm trying to upgrade the firmware in my Netgear MA311 PCI card.&nbsp; I believe the current station firmware is 
1.3.6, <br>
and I want to upgrade to 1.7.4 so I can use WPA.<br>
<br>
I'm using either hermes or orinoco_pci driver (not sure which), and I know that I can bring the card up on eth0 (bizarre).<br>
The card communicates fine currently on eth0.<br>
<br>
However, hostap_diag -a eth0 yields:<br>
<br>
ioctl[PRISM2_IOCTL_HOSTAPD]: Operation not supported<br>
Missing wlan component info<br>
could not read wlan RIDs<br>
<br>
This must be a simple problem..&nbsp; I found one guy on this list who had a similar problem,<br>
but that was apparently a pcmcia card.&nbsp; He just restarted cardmgr to fix that.<br><span class="sg">
<br>
Harold<br>

</span>