<html>
<body>
May be it's the same that happen to me with the Rev. B1 .<br><br>
My problem was that the primary firmware of the card was too old and that
there was no station firmware.<br><br>
So, I flashed the card with PRI 1.1.1 and STA 1.8.0 following the
instructions in
<a href="http://linux.junsun.net/intersil-prism/" eudora="autourl"><b>http://linux.junsun.net/intersil-prism/</a></b>
(I used the prism2_srec in linux to load the firmwares).<br><br>
Then I tried again and now it's working great.<br><br>
I never heard about a Rev. P1, but if it is a Prism2.5 card it may be work.<br><br>
César Reyes<br><br>
PS: who help me the most was "AP-Research" and the subject of the e-mail was "Help configuring DWL-520 Rev.B1"<br>
Good Luck<br><br>
<br>
At 20:43 01-07-2004, T.J. Kniveton wrote:<br>
<blockquote type=cite class=cite cite="">Hi folks, I am new to the list, and wanted to ask a question.. first off,<br>
thanks to Jouni Malinen for making this driver.<br><br>
I am testing with a Prism2.5 card, the SMC2532W-B (which shows up in the<br>
system log as a Zcomax XI-325H 200mW), and also want to try the D-Link<br>
DWL-650, rev P1.<br><br>
With the D-link, when I insert the card, the sys log shows that it was<br>
recognized as the proper card, and the HostAP driver is activated.<br>
However; when I issue a "ifconfig wlan0 up", it fails to bring the<br>
interface up. Any successive iwconfig commands fail.<br><br>
Is this a known problem? I couldn't find the answer by doing a search...<br><br>
Thanks,<br>
TJ<br><br>
_______________________________________________<br>
HostAP mailing list<br>
HostAP@shmoo.com<br>
<a href="http://lists.shmoo.com/mailman/listinfo/hostap" eudora="autourl">http://lists.shmoo.com/mailman/listinfo/hostap</a></blockquote></body>
</html>