set_ap_wps_ie in driver_nl80211
johannes at sipsolutions.net
Fri May 6 05:04:27 EDT 2011
On Fri, 2011-05-06 at 11:46 +0300, Bartosz.Markowski at tieto.com wrote:
> What about this comment:
> * This will also be used to add P2P IE(s) into Beacon/Probe Response
> * frames when operating as a GO. The driver is responsible for adding
> * timing related attributes (e.g., NoA) in addition to the IEs
> * included here by appending them after these buffers. This call is
> * also used to provide Probe Response IEs for P2P Listen state
> * operations for drivers that generate the Probe Response frames
> * internally.
> int (*set_ap_wps_ie)(void *priv, const struct wpabuf *beacon,
> const struct wpabuf *proberesp,
> const struct wpabuf *assocresp);
> Especially part for drivers that generate the Probe Response frames internally?
Yes. My old comment applies to that:
That doesn't make any sense, the whole beacon is programmed and probe
responses are sent by hostapd.
More information about the HostAP