About how to configure hostapd.eap_user for eap-aka

彦 张 yzhang0528 at hotmail.com
Thu Jan 27 01:45:21 EST 2011


Hi, Jouni,
Thank you for your reply.
Now, when I uncommented driver=wired, the hostapd can work fine, can receive message, but i don't know if the paramter is effect my feature test.
I have the following question need your help.
1. after make hlr_auc_gw, I don't know how to enable it? 
2. if we can enbale hlr_auc_gw byhostapd_cli, but the following error when operate hostapd_cli:
   Could not connect to hostapd - re-trying
 
can you give me some suggestion.
 
Regards,
Yan
 
 
> Date: Mon, 24 Jan 2011 13:23:02 +0200
> From: j at w1.fi
> To: hostap at lists.shmoo.com 
> Subject: Re: About how to configure hostapd.eap_user for eap-aka
> 
> On Mon, Jan 24, 2011 at 09:45:26AM +0000, 彦 张 wrote:
> > I couldn't uderstand eap-aka in hostapd.eap_user, I only need eap-aka for phase 1 and no phase 2.
> > i don't know how to configure the following:
> > # Default to EAP-SIM and EAP-AKA based on fixed identity prefixes
> > "0"* AKA,TTLS,TLS,PEAP,SIM
> > "1"* SIM,TTLS,TLS,PEAP,AKA
> > "2"* AKA,TTLS,TLS,PEAP,SIM
> > "3"* SIM,TTLS,TLS,PEAP,AKA
> > "4"* AKA,TTLS,TLS,PEAP,SIM
> > "5"* SIM,TTLS,TLS,PEAP,AKA
> 
> You can leave those as-is or if you know that you will only be using
> EAP-AKA, you can simplify that to be as follows:
> 
> "0"* AKA
> "2"* AKA
> "4"* AKA
> 
> These are used to select EAP-AKA based on the standard user identity
> values used for it. This is all for Phase 1. Please note that you will
> then need to configure hlr_auc_gw with the actual authentication
> parameters for AKA.
> 
> -- 
> Jouni Malinen PGP id EFC895FA
> _______________________________________________
> HostAP mailing list
> HostAP at lists.shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20110127/3930602d/attachment.htm 


More information about the HostAP mailing list