WPA2 Encryption key: off?
tramni at abv.bg
Sat Jul 10 06:05:10 EDT 2010
I am running 64-bit Slackware Linux-13.1 with kernel-generic-18.104.22.168. I have a Wireless-N Home Router WRT120N Linksys Cisco. I followed
to set up my wireless network with WPA2 encryption. I configured the router to use WPA2 Personal security mode with AES encryption. I generated the code associated with the passphrase, following the same Wiki and put the code into wpa_supplicant.conf. Everything works now and knemo says: Encryption: active. However, "iwconfig wlan0" says:
bash-4.1# iwconfig wlan0
wlan0 IEEE 802.11abgn ESSID:"blitz"
Mode:Managed Frequency:2.472 GHz Access Point: 00:25:9C:DE:D3:7D
Bit Rate=1 Mb/s Tx-Power=15 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Link Quality=70/70 Signal level=-26 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
"wpa_cli status" says:
bash-4.1# wpa_cli status
Selected interface 'wlan0'
So is there anything wrong with that "Encryption key: off" statement? I suspect that encryption key only applies to WEP, but not to WPA2 encryption, but I am not sure. Also, could it be due to the fact that in the "Basic Wireless Settings" of the router for the "Configuration View" I have chosen "Manual" rather than "Wi-Fi Protected Setup"? I haven't chosen to automatically configure the wireless security because I do not know whether my wireless card Intel Corporation WiFi Link 6000 Series (rev 35) supports Wi-Fi Protects Setup.
So my question is, why iwconfig says that the encryption key is off, when my WPA2 encryption is active. Are there any other commands to make sure that my encryption is active and safe and well?
Бонус за Световното първенство – заложи 20 евро, спечели 30 евро
More information about the HostAP