How do i know that i am using Host-AP for my PCMCIA Card...

Jar jar at pcuf.fi
Mon May 15 03:21:25 EDT 2006


> [17181203.040000] eth0: Hardware identity 800c:0000:0001:0000
> [17181203.040000] eth0: Station identity  001f:0000:0001:0008
> [17181203.040000] eth0: Firmware determined as Intersil 1.8.0
> [17181203.040000] eth0: Ad-hoc demo mode supported
> [17181203.040000] eth0: IEEE standard IBSS ad-hoc mode supported
> [17181203.040000] eth0: WEP supported, 104-bit key
> [17181203.040000] eth0: MAC address 00:02:6F:39:B9:57
> [17181203.040000] eth0: Station name "Prism  I"
> [17181203.040000] eth0: ready
> [17181203.048000] eth0: index 0x01: Vcc 3.3, irq 3, io 0x3100-0x313f

It seems that the orinoco_cs is loaded first and you actually use orinoco driver
instead of hostap driver. Hostap uses wlanX interface names, orinoco uses ethX.

-- 
Best Regards, Jar



More information about the HostAP mailing list