WPA not associate with both SSID broadcast/non-broadcast
jkmaline at cc.hut.fi
Fri Jan 21 22:30:44 EST 2005
On Fri, Jan 21, 2005 at 12:17:47PM -0800, Jason Schoonover wrote:
> The SSID "work" is not being broadcast, and to get on this I have to change
> the var ap_scan=2. That works great.
> The SSID "home" is being broadcast, and I need to set ap_scan=1, which works,
> however it doesn't work with ap_scan=2.
This is not completely correct.. You should be able to use ap_scan=2
with this network, too. You would just need to explicitly set all
options for it. However, ap_scan=2 does not currently support more than
one network in the configuration file.
> Is there some kind of config option that I'm missing? Is this even possible
> to do? I'd read that ap_scan=2 can only be used for one network block.
You can do it with per-network scan_ssid=1, _if_ the driver supports
scanning for a specific SSID, i.e., you would need to change the driver
you are using..
It should be possible to change the ap_scan=2 mode to go through all the
configured networks with a small timeout on each one, but this has not
yet been done.
Jouni Malinen PGP id EFC895FA
More information about the HostAP