Problem with two cards

[Paulo Sergio Lemes Queiroz]

Jerry wrote:

>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc06 (len=2) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fd42 (len=6) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc0e (len=34) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc84 (len=2) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc83 (len=2) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc82 (len=2) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fc09 (len=2) -
>>    
>>
>no PRI f/w
>  
>
>>Feb  5 09:33:26 border_13_1 kernel: wlan1: cannot get RID fd48 (len=2) -
>>    
>>
>no PRI f/w
>
>
>This would appear to be a prism3 without primary firmware on the card.   You
>need to get the firmware and load it at card initialization time using
>hostap_fw_load  (edit the file for your configuration).
>
>Now if this isnt a prism3 without firmware, then the 'get next tupple'
>usually indicates the need for 'ignore_cis_vcc=0' in the
>/etc/pcmcia/hostap_cs.conf file (edit the file and look at the bottom for an
>example)
>
>Good luck
>
>Jerryf
>
>
>
>  
>

The primary firmware is: v1.1.1 and the Station one is 1.8.0  on the 
both cards..

Should I change the firmware ?

I already tried 'ignore_cis_vcc=0' but the error persists...

Tks a lot....