wpa_supplicant, ipw2200, association timeouts and other allegations
Samuel Díaz García
samueldg at arcoscom.com
Fri Apr 29 04:17:25 EDT 2005
In the ipw2200 list (and ipw2100) they say me that that issue is a work
in progress, there are more issues than this.
See the "history" for the last 2 weeks and you can see some messages
about the issue you have.
Petros Kolyvas wrote:
> Hi! This is my first post to the list. It was suggested I try my luck
> here by some kind folks at #ipw2200 and #wireless on freenode.
>
> My problems involve wpa_supplicant and my inability to get it to
> associate with my access point. The hardware involved is an Intel
> Pro/Wireless 2200BG (on a dell inspiron 700m) and a D-Link 2100AP
> (currently running with WPA-PSK using CCMP/AES encryption). The setup
> works fine under *cough* that other OS. I would like to be completely
> free of it though.
>
> The laptop is currently running FC3 and today I compiled and installed
> 2.6.11.7 with the appropriate modules and options successfully. I'm also
> using wpa_supplicant 0.4.0 and the latest (1.0.3 at the time of posting)
> ipw2200 drivers. The wireless card will associate correctly with any
> open networks, so at least that much is functioning.
>
> "iwlist eth1 scanning" outputs:
>
> #start
> Scan completed :
> Cell 01 - Address: 00:11:95:BF:A6:4F
> ESSID:"ShiftFocus"
> Protocol:IEEE 802.11bg
> Mode:Master
> Channel:3
> Encryption key:on
> Bit Rate:54 Mb/s
> Extra: Rates (Mb/s): 1 2 5.5 9 11 6 12 18 24 36 48 54
> Quality=93/100 Signal level=-34 dBm
> Extra:wpa_ie=dd160050f20101000050f20401000050f20401000050f202
> Extra: Last beacon: 22ms ago
> #end
>
>
> My wpa_supplicant.conf reads:
>
> #start
> ctrl_interface=/var/run/wpa_supplicant
> ctrl_interface_group=0
> eapol_version=1
> ap_scan=1
> fast_reauth=1
>
> network={
> ssid="ShiftFocus"
> scan_ssid=1
> key_mgmt=WPA-PSK
> psk="secret-or-so-i-hope"
> }
> #end
>
> According to most of the folks who've had some experience with this
> stuff, everything seems in order. But below is the output from
> wpa_supplicant, and I don't know what's going on. Hopefully someone can
> tell me what I did wrong. If not, no worries, thank you so much for your
> time. The lines that have me stumped and which remain suspect are the
> following:
>
> 1. wpa_driver_ipw_init is called
> ioctl[SIOCSIWPMKSA]: Operation not supported
>
> 2. Trying to associate with 00:11:95:bf:a6:4f (SSID='ShiftFocus' freq=0
> MHz)
>
> 3. Authentication with 00:00:00:00:00:00 timed out.
> Added BSSID 00:00:00:00:00:00 into blacklist
>
>
> #Begin complete wpa_supplicant output
>
> Initializing interface 'eth1' conf '/etc/wpa_supplicant.conf' driver 'ipw'
> Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
> Reading configuration file '/etc/wpa_supplicant.conf'
> ctrl_interface='/var/run/wpa_supplicant'
> ctrl_interface_group=0
> eapol_version=1
> ap_scan=1
> fast_reauth=1
> Line: 11 - start of a new network block
> ssid - hexdump_ascii(len=10):
> 53 68 69 66 74 46 6f 63 75 73 ShiftFocus
> scan_ssid=1 (0x1)
> key_mgmt: 0x2
> PSK (ASCII passphrase) - hexdump_ascii(len=26): [REMOVED]
> PSK (from passphrase) - hexdump(len=32): [REMOVED]
> Priority group 0
> id=0 ssid='ShiftFocus'
> Initializing interface (2) 'eth1'
> EAPOL: SUPP_PAE entering state DISCONNECTED
> EAPOL: KEY_RX entering state NO_KEY_RECEIVE
> EAPOL: SUPP_BE entering state INITIALIZE
> EAP: EAP entering state DISABLED
> EAPOL: External notification - portEnabled=0
> EAPOL: External notification - portValid=0
> wpa_driver_ipw_init is called
> ioctl[SIOCSIWPMKSA]: Operation not supported
> Own MAC address: 00:0e:35:74:f6:6f
> wpa_driver_ipw_set_wpa: enabled=1
> wpa_driver_ipw_set_key: alg=none key_idx=0 set_tx=0 seq_len=0 key_len=0
> wpa_driver_ipw_set_key: alg=none key_idx=1 set_tx=0 seq_len=0 key_len=0
> wpa_driver_ipw_set_key: alg=none key_idx=2 set_tx=0 seq_len=0 key_len=0
> wpa_driver_ipw_set_key: alg=none key_idx=3 set_tx=0 seq_len=0 key_len=0
> wpa_driver_ipw_set_countermeasures: enabled=0
> wpa_driver_ipw_set_drop_unencrypted: enabled=1
> Setting scan request: 0 sec 100000 usec
> Wireless event: cmd=0x8b06 len=8
> RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
> RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
> State: DISCONNECTED -> SCANNING
> Starting AP scan (specific SSID)
> Scan SSID - hexdump_ascii(len=10):
> 53 68 69 66 74 46 6f 63 75 73 ShiftFocus
> Scan timeout - try to get results
> Received 274 bytes of scan results (1 BSSes)
> Scan results: 1
> Selecting BSS from priority group 0
> 0: 00:11:95:bf:a6:4f ssid='ShiftFocus' wpa_ie_len=24 rsn_ie_len=0 caps=0x11
> selected
> Trying to associate with 00:11:95:bf:a6:4f (SSID='ShiftFocus' freq=0 MHz)
> Cancelling scan request
> Automatic auth_alg selection: 0x1
> wpa_driver_ipw_set_auth_alg: auth_alg=0x1
> WPA: using IEEE 802.11i/D3.0
> WPA: Selected cipher suites: group 16 pairwise 16 key_mgmt 2
> WPA: using GTK CCMP
> WPA: using PTK CCMP
> WPA: using KEY_MGMT WPA-PSK
> WPA: Own WPA IE - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50 f2 04
> 01 00 00 50 f2 04 01 00 00 50 f2 02
> No keys have been configured - skip key clearing
> wpa_driver_ipw_set_drop_unencrypted: enabled=1
> State: SCANNING -> ASSOCIATING
> Setting authentication timeout: 5 sec 0 usec
> EAPOL: External notification - EAP success=0
> EAPOL: External notification - EAP fail=0
> EAPOL: External notification - portControl=Auto
> Wireless event: cmd=0x8b1a len=23
> Authentication with 00:00:00:00:00:00 timed out.
> Added BSSID 00:00:00:00:00:00 into blacklist
> State: ASSOCIATING -> DISCONNECTED
> No keys have been configured - skip key clearing
> EAPOL: External notification - portEnabled=0
> EAPOL: External notification - portValid=0
> Setting scan request: 0 sec 0 usec
> State: DISCONNECTED -> SCANNING
> #end output
>
> Thanks so much!
> Petros K.
>
>
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
>
>
--
Samuel Díaz García
Director Gerente
ArcosCom Wireless, S.L.L.
mailto:samueldg at arcoscom.com
http://www.arcoscom.com
Móvil: 651 93 72 48
Tlfn.: 956 70 13 15
Fax: 956 70 34 83
-------------- next part --------------
A non-text attachment was scrubbed...
Name: samueldg.vcf
Type: text/x-vcard
Size: 450 bytes
Desc: not available
Url : http://lists.shmoo.com/pipermail/hostap/attachments/20050429/8c57a3b6/attachment.vcf
More information about the HostAP
mailing list