trouble with Engenius card
ferret at frii.com
Wed Jan 7 19:26:47 EST 2004
I've got an Engenius NL-2511CD PLUS card that seems to see my NetGear
router/AP, but it never achieves an ip address. I compiled the hostap
driver and edited the /etc/pcmcia/config file to load the hostap_cs
driver instead of the orinoco driver and the card is recognized and it
attempts to come up. I even receive the two high beeps which usually
indicates success. But after the two high beeps I have no ip address.
Below is output from cardctl ident:
no product info available
product info: "INTERSIL", "HFA384x/IEEE", "Version 01.02", ""
manfid: 0x0156, 0x0002
function: 6 (network)
Below is output from iwconfig upon performing an /etc/init.d/pcmcia start:
Warning: Driver for device wlan0 has been compiled with version 15
of Wireless Extension, while this program is using version 16.
Some things may be broken...
wlan0 IEEE 802.11b ESSID:"HobbitLane"
Mode:Managed Frequency:2.462GHz Access Point: 00:09:5B:51:60:52
Bit Rate:11Mb/s Sensitivity=1/242700000
Retry min limit:8 RTS thr:off Fragment thr:off
Link Quality:92/1 Signal level:-40 dBm Noise level:-100 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:1 Missed beacon:0
Notice that the card sees the AP because it lists the correct MAC address.
Upon performing an /etc/init.d/pcmcia start, there are no syslog messages
indicating that a DHCP lease offer was even made. With a wired card
on the same NetGear router/AP there are messages indicating that pump
received a DHCP offer, lease and ip address.
I'm fairly new to wifi and I wonder if someone could offer me some advice
because beyond this I'm not sure where to start digging. Any assistance
is much appreciated.
perl -e 'print unpack("u30","<0G)U8V4\@4VYY9&5R\"F9E<G)E=\$\!F<FEI+F-O;0\`\`");'
The Castor Project
More information about the HostAP