Dual PCMCIA Is Very Slow

Ryan Abbenhuys sneeze at alphalink.com.au
Mon May 26 01:41:33 EDT 2003


Are they on the same channels?

You'll want to run each card on a different non-overlapping channel.

so channels 1, 6 and 11.
I believe this is the only combination that provides 3 non overlapping
channels.

>I have tried hostap with 1 Zcomax 200mw card on a Soekris and ITX boards
and
>am having pretty good success.  Whenever I put a second Zcomax (or any
other
>Prism based card) into the Soekris or ITX board, performance goes from
>~590KB to 100-200KB on one card and under 100KB on the other.  Is there
some
>special command line option I need to give the module or some other
setting
>that needs to be done?  I ultimately want to be able to run 3 Zcomax's off
a
>single ITX board (3 120 degree sector panels) but I need it to perform
like
>a single card.  Any help would be appreciated.
>
>Thanks in advance,
>Michael Shuler
>
>_______________________________________________
>HostAP mailing list
>HostAP at shmoo.com
>http://lists.shmoo.com/mailman/listinfo/hostap
>
>



More information about the HostAP mailing list