Card initialisation problem under RH8

Ryan Abbenhuys sneeze at igreen.net
Sat Jan 25 21:00:06 EST 2003


Occasionally my WL200 doesn't seem to initialise properley at bootup and
sometimes requires that I restart the pcmcia service several times before it
kicks in.
The system is Redhat8 running kernel 2.4.20

The following is the output from dmesg.
Does this shed any light on what might be happening?


hostap_crypt: registered algorithm 'NULL'
hostap_cs: 0.0.0 CVS (Jouni Malinen <jkmaline at cc.hut.fi>)
hostap_cs: setting Vcc=33 (constant)
hostap_cs: CS_EVENT_CARD_INSERTION
prism2_config()
hostap_cs: setting Vcc=33 (from config)
Checking CFTABLE_ENTRY 0x01 (default 0x01)
Config has no IRQ info, but trying to enable IRQ anyway..
IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
io->flags = 0x0046, io.base=0x0000, len=64
hostap_cs: index 0x01: Vcc 3.3, irq 16, io 0x0180-0x01bf
hostap_cs: Registered netdevice wlan0
wlan0: prism2_open
prism2_hw_init()
wlan0: init command completed too quickly - retrying
prism2_hw_config: initialized in 9604 iterations
wlan0: hfa384x_cmd: entry still in list? (entry=dfe699a0, type=0, res=0)
wlan0: hfa384x_cmd: command was not completed (res=0, entry=dfe699a0,
type=0, cmd=0x0001, param0=0x0000)
wlan0: MAC port 0 enabling failed
wlan0: could not enable MAC port
wlan0: prism2_close
wlan0: hfa384x_cmd: entry still in list? (entry=dfe7e320, type=0, res=0)
wlan0: hfa384x_cmd: command was not completed (res=0, entry=dfe7e320,
type=0, cmd=0x0021, param0=0xfd0b)
wlan0: hfa384x_get_rid: CMDCODE_ACCESS failed (res=-110, rid=fd0b, len=8)
Could not get RID for component NIC
wlan0: PRI: id=0x15 v0.3.0
wlan0: STA: id=0x1f v1.4.9
wlan0: defaulting to bogus WDS frame as a workaround for firmware bug in
Host AP mode WDS
wlan0: LinkStatus=2 (Disconnected)


--
Regards,
  Ryan Abbenhuys

sneeze (at) alphalink.com.au
rabbenhuys (at) mfbb.vic.gov.au
ryana (at) igreen.net
sneeze (at) igreen.net




More information about the HostAP mailing list