Dead card after failed firmware flash?

Martin Polak martin.polak at liwest.at
Fri Nov 22 06:30:16 EST 2002


Hi All!

It finally has happened:

I wanted to flash a new firmware into my netgear MA401 using a 
windows-notebook. When flashing was in progress, suddenly the notebook 
made a reset, leaving my card f***ed up.

hostap now can't initialize the MAC-port und windows just says, that 
there is something wrong with the card.

A speciality is, that when I am using newest 2-0-9 Prism-Drivers vom 
Intersil, the card gehts started (I believe using the RAM-DL 1.5.6 
firmware it shows) and "looks" fine. (cant test it, because of the 
absence of an AP :-)
In this config it is also reported by the Flash-tools, but an upgrade 
always fails (couldnt write PDA).

Does anyone know a solution to recover my card?


help
appreciated

Martin




More information about the HostAP mailing list