wlan0 Interface seems to freeze.
praedor at yahoo.com
Mon Dec 9 06:33:37 EST 2002
I get essentially the same problem, sans the dmesg message, with my WUSB11
v2.6 (atmel driver). I have a good connection to my laptop (using pcmcia
Zoomair prism2 and hostap), kernel 2.4.18, which NEVER goes down or has a
problem as you describe. My WUSB11, however, works for some hours (sometimes
half a dozen or more, sometimes just a few) but then just stops responding
and resetting is impossible. The only way to get it back is with a reboot.
The problem appears similar to your prism2 problem though from totally
different system (different device type - atmel - and interface - usb).
On Monday 09 December 2002 04:30 am, Theodor Milkov wrote:
> On Tue, Dec 03, 2002 at 02:12:59AM +1100, Chincogan Network Services Lists
> > Hi List,
> > I have a problem where my wlan0 interface seems to freeze, a dmesg shows
> > pages and pages of this: wlan0: prism2_tx: hw not ready - skipping
> > wlan0: prism2_tx: hw not ready - skipping
> > Doing a "iwpriv wlan0 reset 1" does nothing, to fix this I have to
> > restart pcmcia. Sometimes this problem will leave us for a couple of days
> > other times this will happen multiple times a day.
> > This afternoon I am going to change this card with a Dlink DWL-520 to see
> > if that makes any difference.
> > My Setup:
> > Hostap 2002-10-12
> > Kernel 2.4.19
> > Pcmcia_cs 3.2.1
> > Compaq WL-200
> > Once I change the card I will not be using pcmcis_cs anymore as the
> > DWL-520 is a PCI based prism 2.5 chipset. Does anyone have any ideas why
> > this could be happening? I hope it goes away with the new card because it
> > is really starting to get annoying.
> Just to confirm the same problem here. My setup is very similar to
> hostap 2002-10-12
> kernel 2.4.18
> pcmcia-cs 3.2.1
> Compaq WL-200 (STA 1.4.9)
> Ricoh PCI-PCMCIA adapter + Senao 2511 (STA 1.4.9) instead of WL-200
> works just fine for weeks. So it must be something with WL-200s.
> Kindest regards,
More information about the HostAP